Mini Metal Shear / Brake

Large Image

Mini Metal Shear / Brake

Mini Metal Shear / Brake
Starting at $199.95
Sold Out! This item has been discontinued and is no longer available.


Combination Shear and Bending Brake for Precision Sheet Metal and Circuit Board Fabrication

This double-featured miniature machine will save you hours of tedious sheet metal fabrication and finishing. The upper section is equipped with a sharp 7-1/2 inch wide shear that smoothly cuts circuit board stock up to 1/16 inch thick; copper, brass, aluminum and tinplate sheet up to .040 inch thick. The lower section is a powerful bending brake that bends sheet metal up to 90 degrees and 7-1/2 inches wide. The integral gearbox triples the torque you apply to the hand lever so less force is needed to get the job done. Includes six bending dies of various widths for tray and pan forming operations, and adjustable stops for making duplicate parts. Shear blade has four pre-sharpened edges for long life. Overall dimensions: 11 inches wide x 6 inches deep x 13 inches high over handle. Approx. weight 30 lbs. Color may vary.

Shipped by UPS ground to 48 contiguous U.S. only. For other areas, contact Customer Service for special arrangements.

View Instructions

Click HERE to view instructions
Tell a Friend
Close [x]
You can send this product by email to a friend!
Enter the required information in the spaces provided below. They will receive an Email with the picture of this product and a link back to our site.

Your Name:

Your Email:
Friend's Name:
Friend's Email:
Alternates / Accessories / Options
4-Edge Lower Blade
Item #: 83215
Close Out!: $17.15
4-Edge Lower Blade

4-Edge Upper Blade
Item #: 83214
Close Out: $17.15
4-Edge Upper Blade