 |
| The #81387 Saw Mounting Plate may be used to mount the following saws to the edge of your workbench: #60514 MicroLux Multi-Saw, #50304 MicroLux 2" Table Saw and #80463 Tilt Arbor Table Saw. | |
 |
 |
| Figure A | Figure B |
| To mount either the #60514 MicroLux Multi-Saw or the #50304 MicroLux 2" Table Saw, use the 3 long screws and washers provided to attach the plate to the bottom of the saw housing, as shown in Figure A. | To mount the #80463 Tilt Arbor Table Saw, use the four short screws provided to attach the plate to the bottom of the saw housing, as shown in Figure B. |
| When mounting the saw to your work bench, be sure to turn the clamping screws just enough to secure the bracket and saw. Over-tightening the screws may distort the bracket.
If the edge of your workbench is very thin, put a small shim strip under the workbench top so that the clamps can secure the bracket properly. |
|
Go to #81387 Catalog Page