 |
 This ingenious tool cuts a perfect 90 degree corner in wood and plastic. It's ideal for cutting window and door openings in model siding and structural materials. Simply mount the punch in your drill press and pull the handle. Or, just hold the punch with your fingers and tap the rounded end of the punch with a hammer. (To protect the sharp edge of the corner punch, be sure to place a piece of hardwood or scrap plywood under the sheetwood to be punched). Step and repeat the operation, and your job is complete. Also good for cleaning out routed corners, trimming dollhouse openings, cutting square holes for model airplane construction...and any time a precise 90 degree corner is needed. Made of tool steel with razor-sharp cutting edges. Can be resharpened easily on any honing stone (see instructions on reverse side). Note: This product is guaranteed to be sharp when new; however, since the use of the tool is beyond our control, we cannot replace the product if dulled or nicked by the user. Safety glasses are recommended when using this product. |
|
 | |
Go to #81652 Catalog Page