Peel-and-Stick High Intensity LED Lighting for Confined Spaces and Special Effects
Our Multi-Color RGB (Red/Green/Blue) high intensity peel-and-stick LED (Light-Emitting Diode) strips add special effects to places regular lighting fixtures can't. Each LED contains 3 color chips . . . red, green and blue . . . each color wired to its own circuit. The circuits may be wired for individual control through dimmers, or use a control sold below to select preset colors and special-effects color sequences. The flexible strip is only 10mm (3/8 inch) wide, and is supplied in a 5 meter (16 foot) reel that contains 300 LEDs spaced on 16.72mm (approx. 5/8 inch) intervals. Just use a scissor to cut the reel into shorter strips . . . a safe cutting location is marked after every three LEDs. Low voltage (12VDC) electrical requirements make wiring quick and easy (connect cut ends with clips sold below).
Includes 44-Key Infrared Remote Control!
Our 44-key infrared remote control allows you to create a variety of color light effects with our multi-color RGB LED light strips described above. Vary the intensity of each of the three color channels individually to create any possible color and save it as one of 6 DIY keys for ready access. The receiver plugs into the power supply and the multi-color LED light strip. The remote control allows you to choose either 20 pre-set colors, or select from 6 pre-programmed color-changing cycles, along with an auto-cycle. You can also control brightness and the color-change cycle rate.
Includes CR2025R battery for remote.
Note: Our high intensity LED light strips use high-output SMD5050 LEDs that out-perform cheaper versions. Includes one 4-pin connector installed on end of reel that connects with our color controllers. Electrical requirements: 12VDC; 1.2 amps per meter.